aluminum boat

[Robin Matulja]

Hello to all,
Could somebody tell me which is the approximate weight of aluminum as the construction material in the 30' motor boat?

 

[Village_Idiot]

I think that it really depends on the application (what will the boat be used for? what is expected of it?), but I think at a minimum you would want 0.250-inch for the bottom and 0.125-inch for the rest. It also depends on how the boat is built - if you have a lot of good structural ribs, etc., you could probably get away with a bit lighter gauge.

 

[daiquiri]

You should go for Aluminum 5083-O
http://www.matweb.com/search/DataSheet.aspx?MatGUID=d105c2a24d6942cdad79259f770fb806&ckck=1

or Aluminum 5086-O
http://www.matweb.com/search/DataSheet.aspx?MatGUID=d0271cf3b5f84d63a17e328d02419587

Density of both is about 2650 kg/m3.


P.S. (sorry for you other guys...):
Kontaktiraj me na private ako ti treba savjet ili pomoc.

 

[lazeyjack]

depends on your speed requirements and sea state fast boat at sea, in good sized chop, I would plate in 8mm the bottom with 5 mm, full length girders, for slow boat, 6mm
I would use 5 on the topsides, and 4-5 on deck and 4 on superstrucure
your bottom is critical you can pm me and I will send you some drawings, I have built many al al yachts and motorboats
Stu

 

[daiquiri]

Ah, maybe I have misunderstood the question... He was talking about the weight, so I gave him the weight.

 

[Robin Matulja]

yes I was talking about the weight (measured in kilos or pounds)
thanks to all anyway!

 

[Robin Matulja]

Hvala ti na pomoći!

 

[Alik]

For 30' planning powerboat the weight of hull, deck and cabin structure designed to ISO12215-5 will be about 1800 kg.

Thickness is likely to be 6 mm at bottom provided that bottom panels are about 300-350 mm wide. For rest of structure thikness is about 4 mm. These data not for construction, just for quick reference

 

[Robin Matulja]

thanks Alik!