The Boat Design & Boatbuilding Site
Aveva Tutorial Lines
- Thread starter pdmsvn
- Start date
Could you tell me the way how you imported file igs into Aveva Marine?
In my view, i imported igs hullform to Surface manager module in Aveva and optimized it, the gap is around 0.0005mm might be accepted according to standardization of program. If thế gap is too big, you should modify igs hullform file then import it again.
Don't hesitate to send email to me if any troubles in Aveva Marine: training.aveva@gmail.com
In my view, i imported igs hullform to Surface manager module in Aveva and optimized it, the gap is around 0.0005mm might be accepted according to standardization of program. If thế gap is too big, you should modify igs hullform file then import it again.
Don't hesitate to send email to me if any troubles in Aveva Marine: training.aveva@gmail.com
So gap between trimmed surface can be less than 0.0005mm??? And there is no problem with structure modeling for such surface?
As i know that when modeling structure in planar hull, If boundary of plate is surface then that surface is not interrupted, it must be such a continue curve (not broken off)
Attachments
Have you any chances to import lines I sent to you?
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
Advertisement:
