Infusion - resin up and down..

OK, idkfa, I have posted it on rapidshare, can you tell me how to let you know how to get to it, I cannot see how to do it. Ta, John

 

There somewhere must be a link to the file or the download page, you can spread that link around (or post it here).

 

Herman, please advise if you know where to find it, I have not been able to do so......

 

here it is John!

http://rapidshare.com/files/433544480/DIAB_Resin_Infusion_Manual.pdf

 

Thanks Apex, there are a few people here that would like to get to that file.

 

Welcome John.
I took the freedom to login there to find out what was the working link.

 

http://rapidshare.com/files/433988677/DIAB_Resin_Infusion_Manual.pdf

 

404
File not found..

But does not matter, my link (provided by Landlubber) works..............

 

a quick suggestion

Seriolla,

I took a quick look at your photos and have the following suggestion.

Move both heli-tube epoxy supply line to lay on top of the edge of the infusion media, equally distant from the part. Your current set-up appears to have the bag hard to your lower mold surface which will cause the epoxy to struggle a bit to get to the part.

Allan

 

variverunner, thank you. I have seen on the downloaded pdf from this thread, page 57, same suggestion. My new test piece is ready, I'll try to infuse today.
brgds

 

Good luck Seriola,

Keep us posted with your results

Allan

 

This time the infusion was perfect! It took about 3 minutes (3x400g+25mm+2x400g). I did not used the top inlet. Thank you for help