Ice-box corner filet material under epoxy & glass…what to use..?

Discussion in 'Fiberglass and Composite Boat Building' started by paularey, Oct 9, 2006.

  1. paularey
    Joined: Oct 2005
    Posts: 32
    Likes: 0, Points: 6, Legacy Rep: 10
    Location: Panama

    paularey Junior Member

    I am just getting ready to finish the final assembly of a rather large built in ice-box under the cockpit seating area of my catamaran and I was wondering what might work best for filleting/adding a small radius to the corners before laying some fiberglass tape to the seems with epoxy resin…? Brief description my ice-box is approximately 24 inches deep by 24 inches wide by 34 inches across. And is made out of 4 inch thick Styrofoam panels with a thin but solid layer of woven fiberglass & chopped strand matt combination bonded to one side with epoxy resin. I fitted the pieces (foam only) in place then removed them individually and glassed the interior portions while horizontal in my shop. The panels turned out really nice now I just want to install them into the ice-box frame and seal all the corners with a narrow stripe of fiberglass tape but I would like to lay a small radius of some kind of filler/fairing compound in the corners before doing so. I was going to us a polyurethane chalking but I thought it might be better to have a solid material to back up the glass. I am in Panama so my resources are limited. Is there anything wrong with using bondo or a similar material? I only plan on laying in a small radius so the tape will transition the corners smoothly. I am a novice with composites so any input is appreciated. I would like to avoid something that can absorb water and lower my ice-box efficiency.

    Thanks
     
  2. JR-Shine
    Joined: May 2004
    Posts: 341
    Likes: 4, Points: 18, Legacy Rep: 54
    Location: Vero Beach, FL

    JR-Shine SHINE

    mix some microballoons into the epoxy to make your fillet. Bondo being polyester will not bond well (or at all) to the epoxy you have already used. If you cannot find micro ballons you can use talc or silica or fine wood flour to make these fillets.
     
Loading...
Similar Threads
  1. samir elbaguer
    Replies:
    11
    Views:
    2,945
  2. Biloxi Bertram
    Replies:
    18
    Views:
    2,664
  3. ltweardy
    Replies:
    2
    Views:
    90
  4. Wesley2022
    Replies:
    6
    Views:
    216
  5. fallguy
    Replies:
    22
    Views:
    641
  6. massandspace
    Replies:
    7
    Views:
    385
  7. bajansailor
    Replies:
    13
    Views:
    567
  8. massandspace
    Replies:
    2
    Views:
    625
  9. Mark C. Schreiter
    Replies:
    4
    Views:
    581
  10. vroomZOOM
    Replies:
    8
    Views:
    1,089
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.