Chris Craft Barrelboat Model Rhino3D

Discussion in 'Software' started by mikejohn, May 12, 2018.

  1. mikejohn
    Joined: Oct 2012
    Posts: 10
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Brisbane

    mikejohn Junior Member

    Your right the keel is not straight. I did not notice. I really don't know how I did that. I drew it in the right window assuming that would keep it straight in the other directions I guess. Thank you.
  2. bhnautika
    Joined: Feb 2006
    Posts: 849
    Likes: 56, Points: 38, Legacy Rep: 571
    Location: australia

    bhnautika Senior Member

    Mikejohn there is a quick way to fix the problem. Select the line, In the transform menu about half way down there is “set XYZ coordinates “. In the dialogue bow un-tick the one’s you don’t want ( you want the X in this case) press enter, then snap on to the centre line. This also works on the control points so you can straighten the edge of a surface.
    rwatson likes this.

  3. DCockey
    Joined: Oct 2009
    Posts: 5,005
    Likes: 493, Points: 83, Legacy Rep: 1485
    Location: Midcoast Maine

    DCockey Senior Member

    The command line version is SetPt
    rwatson likes this.
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.