ANSYS CFX freesurface solution (Help)

Discussion in 'Software' started by idefix26, Apr 11, 2014.

  1. idefix26
    Joined: May 2012
    Posts: 4
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Europe

    idefix26 New Member

    Hi.

    I want to calculate hull resistance in Ansys CFX. I can calculate hull resistance in Fluent but I want to try CFX.

    I can set up CFX for single phase solutions.

    How can I set up in CFX for multiphase solution? (freesurface calculation)
    (Fluid flows: Above waterline air, below waterline water)

    Boundary conditions, domains, interfaces, values etc?

    Can anybody help me about setting up the CFX for boat analysis?
    Is there any tutorial for my topic?
     
  2. Leo Lazauskas
    Joined: Jan 2002
    Posts: 2,696
    Likes: 149, Points: 63, Legacy Rep: 2229
    Location: Adelaide, South Australia

    Leo Lazauskas Senior Member

    You might be better off asking this question on cfd-online, e.g. try:
    http://www.cfd-online.com/Forums/cfx/
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.