yeah, that paint might be hard to match.... but gray goes with everything!
As soon as I can scrape up the money, I'll be buying this. I sure haven't seen anything else that would be a good fit for my Yamaha P60 for the...
it actually has two 6" inspection plates near the stern, to allow access to the live bait well valves. I would be removing the bait well...
I went to look at a 16' wooden skiff the other day to replace my cracked and failing aluminum one. The one that I am looking at is plywood...
I've built three SOF kayaks, and ribbed two of them with black locust, one with Oregon white oak. The first one was with locust stock that had air...
I would be using it more in saltwater than fresh. I think I will go ahead and strip it down when the weather gets reliably nice and see what I...
I think the glassing was more of an incomplete job than a lousy one. He just did the first layer and then stopped working on the boat, and it sat...
well, one reason to keep on with this one is if I can save it, I save 2 or three thousand dollars in materials and a whole lot of hours. I...
any reason not to just strip all that bad glass off, clean and dry the wood well and just paint it? Why all the fuss with the glass and epoxy?...
So, about two years ago, I picked up this newly constructed and abandoned plywood hull for free. It was built from 24' hankins cuddy cabin plans....
skin on frame is fast and cheap and fun. use artifiical sinew from the leather supply store for lashing everything. I have paddled a night heron...
mine wouldn't be a critical part of hull strength. the hull is 3/4 thick ply on the sides and 1' on the bottom. I notice when I look at newer...
the plan shows three per side, the ones closest to the keel being shorter than the outside ones, not running all the way to the stern. It is...
