Do you think using epoxy all around the bottom and sides to hold in the transome along with fiberglass on the outside and inside corners will hold...
Thanks for your info. I did not remove any of the hull - only the transom wood which had to be completely removed because it was allo bad right up...
Hi, I recently aquired this 1959 Glass Craft Sportster. The wooden transom was rotten so I removed it along with all the wood on the back. Now...
I ended up removing all of the wood yesterday and now have just the fiberglass sides and bottom. Good thing I did cause the wood was not good on...
I cut out the transom today and left some edge on the side that may help attach a new transom in. I was wondering if I could sandwich the new...
I removed the two braces just now that was between the bottom and the transom. The part that the braces were connected to on the floor are like...
You can see the braces and where the floor ends and drops to the bottom of the boat. Any suggestions on how to tackle this? Just cut out the...
Thanks everyone! The bottom of the hull is excellent. And after putting it in my garage, I got in the boat after cleaning out two wheel barrels...
There is a floor in this one believe it or not. I didn't think there was either but it does have a floor.
Thanks for your replies. I'm wondering if I should cut out part of the floor to check the bottom stringers? I cleaned the boat out today and the...
I just aquired this boat today and the transom is rotted so the whole thing needs replacing. There are two braces holding the transom. There are...
I have been reading the epoxy information for Poxy Grip which I have for building my frames. As I have read in the forums, it also states not to...