You could try the J-35 OD association they make have a set of offsets.
Well that's just a stupid limitation. So to use Orca's resistance prediction you have to run it on a half hull?
Perfect, thank you very much.
Thanks for the suggestions! I have been trying to convince my school (UNO) to hire a grad student to explore using an infinite Z axis 3d printer...
I found some old copies of Michlet to play with, but I couldn't find any data on the circumstances it works well with. So at this point I am...
Its for coursework so a model is pretty unlikely. I did something similar to you for another project with a loadcell and my powercat, but for this...
David, The design speed is supposed to be 6kn, which results in a demi-hull Rbare of 80.1N (Holtrop) and a Fn of .378. Correct the L/B is for...
I am running a resistance model on a very high L/B catamaran and am running into an issue where NavCad doesn't have any predictive models that are...
I don't have anywhere to put an inboard, and for an outboard you run into intake problems. I guess you could go with an air cooled long tail mud...
An autopilot is much more expensive than a trolling motor and far less effective since they typically can't control the throttle as well. I would...
I am at about $11,000 in parts give or take, so I had the budget for some small toys.... - The anchor winch is just a person favorite,...
A current 70hp Yamaha has a distance from the water intakes to the bottom of the skeg of 14.5 inches. His may be a little different given its age,...
Ya, I keep trying to figure out where to put a trolling motor. The current plan is to have it on the port bow, but to get one that can self deploy...
It would have been an interesting option to be sure. But I will bet a dollar my boat ends up being shallow draft. He is planning on using a 70hp...