All the holes will be overbored and filled with epoxy bog then redrilled, if not permanently filled. I was concerned, a bit, of the possibility...
I recored my transom with MDO and DF plywood, and reskinned the interior with glass and epoxy. My question pertains to all of the bolt holes and...
"Just asking the question shows that you're taking more care with the installation than 99.9% of commercial contractors." But, there is a need to...
Thank you everyone!
I am wanting to use epoxy on the wood framing around the entrance door to the cabin.The door itself is aluminium, and will be set into the...
Not knowing what engine you have , I would still say you have low boost out of the turbos. .7 bar seems low, and the black smoke indicates, a...
A few years back I wandered into this forum to ask some questions about a restoration I was working on, (and am still). PAR chimed right in with...
TBHD = total bulkhead diameter then? If so I understand the formula thank you again.
I'm using 3/4 Arouco, which is a pine based exterior. It's actually quite a bit better than a lot of the MDO and "marine" I have seen in my area....
A pic of the forward bulkhead/galley counter assembly[ATTACH]
A couple years back I gutted out a 28 ft cabin cruiser, down to the stringers. Originally the the only bulkhead /transverse frame, was the cabin...
Thank you! As always you are most helpful. Happy Holidays.
