Recent Content by reelpleasure

  1. reelpleasure
    Thread

    Working with NidaCore (Plascore) panels and Nida Core Bonding compound

    I did some experimenting yesterday with a couple of pieces of scrap Plascore. The pieces are leftover cuts from stringers going into the 25 T...
    Thread by: reelpleasure, May 27, 2014, 0 replies, in forum: Fiberglass and Composite Boat Building
  2. reelpleasure
    Post

    Polyester resin over polyurethane enamel

    one part
    Post by: reelpleasure, May 15, 2014 in forum: Materials
  3. reelpleasure
    Thread

    Polyester resin over polyurethane enamel

    Question for the paint and resin experts??? I am rehabbing my 25 Terry Jason lobster boat. The helm dash is reconfigured and I have a...
    Thread by: reelpleasure, May 15, 2014, 4 replies, in forum: Materials
  4. reelpleasure
    Post

    Layup schedule for Nidacore deck joists??

    6 joists all laminated up. Dark ones are VE resin with red MEK Light ones are polyester with clear MEK
    Post by: reelpleasure, May 6, 2014 in forum: Fiberglass and Composite Boat Building
  5. reelpleasure
    Post

    Vinylester layup over H80 core 2 sides at once

    The VE resin was purchased from Hamilton Marine in Portland Maine. I had NO issues with fast gel time/heat etc. with 20cc of MEK to 32 oz of...
    Post by: reelpleasure, May 6, 2014 in forum: Fiberglass and Composite Boat Building
  6. reelpleasure
    Post

    Vinylester layup over H80 core 2 sides at once

    I've been using 20cc per 32 oz of vinyl ester resin with good results laying up nidacore joists.
    Post by: reelpleasure, May 5, 2014 in forum: Fiberglass and Composite Boat Building
  7. reelpleasure
    Thread

    Layup schedule for Nidacore deck joists??

    I rebuilding a 25 foot lobster boat for recreational use. Over the fall and winter I removed the back deck and removed everything except from the...
    Thread by: reelpleasure, May 4, 2014, 3 replies, in forum: Fiberglass and Composite Boat Building
  8. reelpleasure
    Thread

    Nidacore layup schedule

    As I go forward with my rebuild/rehab/repower of my 1989 25 T Jason lobster boat, I'm getting to the point of laying up and glassing in lateral...
    Thread by: reelpleasure, Mar 4, 2014, 1 replies, in forum: Fiberglass and Composite Boat Building
  9. reelpleasure
    Post

    Plascore layup schedule

    Recent photos and where I am today with the project
    Post by: reelpleasure, Mar 2, 2014 in forum: Fiberglass and Composite Boat Building
  10. reelpleasure
    Thread

    Plascore layup schedule

    Nidacore layup schedule Hello ALL, I'm a bit new to this forum. You helped my out with suggestions on epoxying some limber holes. As I go...
    Thread by: reelpleasure, Mar 2, 2014, 1 replies, in forum: Fiberglass and Composite Boat Building