Don't worry about the wire speed adjuster on the gun, unless your machine is a synergic unit your still going to have to go back to the machine to...
Adding some more points directly above the problem on the respective frame and adding a new edge solved the issue, thanks a heap guys. I'm...
Thanks guys, your legends, I'll give your ideas a go this evening. Also, at what point or percentage dose a section of UN-developpable plate...
Hmmm, bummer. See we do learn somthing new every day. I can see how my NA earns his money. All a bit dissapointing, I'll have to look into Rhino...
Hi guys I normaly leave the hull modeling to my navel architect but alas he has been beyond flat out lately and has not had time to take on the...
Hi Troy I have had a couple different variations of this problem. One boat had no dramas with trim related porposing but when the motor was...
Yea, probably should have said. I was ready to paint the boat and wanted to weld tube into the top two holes, then paint, then deliver to get the...
Thanks Hugh Some good extra information to know, I cant imagine fitting an engine bigger than 225hp as my workshop isn't big enough to build a...
Found this for those that were interested. "It is believed that the hole arrangement currently in use by most engine manufacturers follows...
I've heard that all modern outboards have the same mounting bolt pattern, is this true? I ask as I need to drill the holes to mount a customers...
You can get some goop called "Pro-seal" I think that is it's official name. Quite expensive, but is one of the few sealants out there that is...
For the brains trust, I'm welding a plate ally box type mounting for a Minn Kota onto the gunnel of the current boat that I'm making. however when...
