Hello Amjad, Maybe if you post the file, we could help... Also, you created the .iges file with Autoship?? I you gave a little more detail....
Thanks again Zeroname, You saved the day once more (I'm thinking about adding you to the credits of my thesis already, ;o) The file worked...
Hello!! I'm back here with my typical problems with converting an Autoship file into an .gf one. I'm ready for my stability study so I need to...
Well, it is a commercial fishing boat made of FRP for purse fishing.
Yes, both are engines that are easily found in this area, however I don't need to have several options because this project is theoretical and is...
Hello everybody! I'm writing my final project in order to get my degree and I'm projecting a FRP fishing boat for seining and I'm trying to...
Thank you so much again Zeroname. Yes, it seems to work fine, I'll check it tomorrow more thoroughly, however please tell me what the problem was...
PS: I keep getting this error message: Error: (H32742) Invalid model: Negative section area at -7,320 on Part/Comp HULL/CASCO
Hello everybody! I'm working on my final project in order to get my degree, I'm working on a fishing boat (L=15m) made of glass fibre...
Thank you zeroname, I solved the problem, and it was the units, that I had meters as outcome unit and it has to be mm so it doesn't go crazy....
Thank you very much, it finally works. Did you do something special? I still don't get what was working wrong.
I tried that and nothing. I uploaded the autoship design I hope there is more luck this time, thank you very much anyway.