I wanted to thank everyone for all of the help and insight you all have provided. It made rebuilding my transom a lot easier. It also gave me...
Also is milled fibers something I can pick up at a big box hardware store or maybe a lumber yard? Or is that something I need to order online?
The panel is held in place by rivets. The problem with making it bigger is I would have to cut out the splash, which is one solid about 4 ft...
Are you talking about G/Flex? I did see that and I was thinking of maybe using that on the outside between the wood and aluminum. Between the...
Thanks for the info on the resin. I'm thinking that I will build it in the garage with heater running to bring ambient temp up and then take it...
Also I'm working on pulling the transom wood today so I'll post some pics of what the box looks like.
Tunnels, Thanks for the the info on the temp and humidity. That was going to be one of my questions since I know chemical reactions like certain...
Par, Attached are the photos of the transom. The wood is under the aluminum plate on the top of the transom and goes under the two corner...
Thanks for the recommendations on the epoxy. I was thinking about using the epoxy for in between the pieces of plywood and then using 3m 5200 for...
Par- Thanks for the feedback. I don't think I'll be able to increase the thickness to 2". Due to the way the boat is built. The wood core is...
I'm wanting to put a aftermarket trim tilt unit on my 1981 lund mr pike 16ft. I am going to replace the wood in the transom this week and after...