thanks folks, it's not very wide, so I am going to lay down some csm then go over with the milled fiber putty, this should give me a strong and...
It's on the deck of a boat, 1/2" plywood core. The deck is just gel coat over CSM. It's a TwinVee, finish is similar to a carolina Skiff. [IMG]
I had to cut out some delaminated CSM with gel coat on top. I was just going to put CSM back in the repair, but I started to think. What if I...
I know that I could use coosa blue water 26 for my deck to replace the 1/2" plywood core that was in there prior. But, if there another core that...
Thank you very much for the help!
PAR, if My last layer of glass for a deck is 1708 with the biax side up, what should I put over that last layer before pulling fairing compound?...
I was talking about cutting the whole area out and then laying down 6 inch x 6 inch squares of kiln dried marine treated plywood. I do like the...
So the deck of my sea cat is getting spongy in some spots. I plan to just cut the top laminate off the sole, then remove the bad wood core....
gonzo?
Where would I find a poly adhensive? I was planning on using the poly I had to glass the 1708 over the coosa. you think one layer of 3/4 mat...
My hatch has succumbed to the elements. I plan on using a sheet of coosa for the repair the same thickness as the old ply. I plan on removing...