I should have bought a double spool valve in thef irst place. But I have two different valves for different task. I am learning the expensive...
Awesome B...Thank you for the advise. The flow rates are way different. 40 gmp on the motor and maybe 10 gpm, (at most) for the cylinder. I...
Well here is my problem. Picture this...IC engine turning a hyd. pump....which goes to a spool valve...which goes to a hyd motor...and the...
looking for 1 inch male JIC that can be welded to 1 .25 inch pipe to withstand 3000 psi thanks mark
I was hoping to have pre made fittings that were welded. Again does anyone know where I might get welded fittings? thanks Mark
We will keep the shaft tube dry and that should help with the seals. We are leaning now, on having the casing wet. The biggest problem with this...
Does anyone know of a wholesale company that will sell welded hyd. fittings for steel or aluminum tubing? thanks Mark
no, there isn't any reason. That is a great point about the if the oil can't get out...water can't get in. We are using bio-hydro oil for the...
Ok, picture this....I have built a proto-type case that in housing a hyd. geared motor that is hexagon in shape. If you look at the hexagon that...
the hyd pump will drive the prop shaft.
Ok, another dumb question.. I am going to have to reduce the engine rpm down to run a hyd pump. The engine runs a max of 4400 rpm but the max...
