In the region of the seams, the fiber was superimposed about 3 inches, creating a region of approximately 6 inches double fiber layer.
On the deck 6mm also covered with FB 100 g / m2.
I used 4mm plywood on the floats and main hull, covering everything with a FB of 100g/m2. It seems to be very solid.
Oldsailor, these structural reinforcements are foreseen in the project Luigi
Float construction detail Do not forget these reinforcements.
Mast profile Thank you oldsailor. The profile of the aluminum tube that I'm planning to use is shown below: Thickness:2.7 mm X: 130 mm Y:...
Questions about the rig of b24. 1. By using the pivotable mast can maintain the same standing rigging scheme? The vectors of the resulting forces...
Thank oldsailor. I agree with you. Better that front had a smooth leading edge. It would be much more difficult to perform. Perhaps a solution...
Thank you Nelson. The design of the beams was inspired by the Capricorn boat. Luigi
No freddyj, it can not be towed. This, in particular, was born to never see the asphalt.:D. Headharbor, this weekend I'll take a look at the...
Designs and ideas about building a rotating support for the mast are welcome.
Progress in building buccaneer 24. Almost done ... After 5 years....................................
As electronic engineer, my knowledge in mechanical vector is limited to college classes, which is taking me to review some information on diagrams...
Thanks for the information, John. I can clearly see what you explained. I'm almost convinced to remake cuts the sides with the grains aligned at...
Buc 24 beams Tks, Jonh. Even having started cutting the pieces, I do not hesitate to change and/or implement a good suggestion. A big...
