I have a hull, deck, and liner mold for sell. The boat is an I/O fish and ski built by Fiberking back in the 90's. They called it Vanguard. I can...
I have 8 unfinished Infinity wakebaord boats and some inventory for sell. This is a v-drive boat with the engine installed backwards at the rear...
use a can of white spray paint and then do what ondarvr said with the sharpie.
ondarvr, is right about all of it. Polyester is the way to go. It wets out better and does not drain as bad. I just had to write something.
tunnels, we used chop on the part. So, yeh it could have been the binder.
I have about 10 rolls of 60" mat that I believe is 1oz. I also have quite abit of 48" veil material. For those who may not know it is glass but...
If the whole laminate looked normal until it started to cure then you are OK. It is just the resin. I have laid up parts using vinyl ester that...
My father and I run a fiberglass shop 50 miles southeast of Nashville TN. We are looking for anyone who might need some tooling (mold) work or...
Drill as many holes as possible say every 18 inches and big enough for the foam to pour without spilling on to the floor. Try to elevate the front...
If you will go and look there is alot more sanitary wear on the market than wooden boats. Some people have moved on.
If you are building a good amount of parts go with the chopper gun. Remember the chopper gun should be used only as a sandwich bed between your...