This may seem like a stupid question but I'm looking at making a laminate that incorporates +45 and -45 degree plys. Since my part is...
Thank you for the reply. This was the feeling I had but it is reassuring to hear this advice from those more experienced than me. I've seen some...
I am planning to infuse some rather large parts and was considering the use of a vinyl ester resin. I was wondering if it would be possible to...
Although I had some faith in them, my hose connections could also be an issue. Currently for both my resin inlets and and air outlets I use the...
I haven't mocked up anything for an infusion just yet but I have been doing small scale samples to test the vacuum. I recognize your concern about...
I appreciate the advice guys. I did purchase the yellow vacuum tape and proper vacuum bag which I have been told are the correct products for...
I am planning a rather large infusion and wanted to get some prospective on the acceptable amount of vacuum leakage you would accept for an...
Thank you for the insight, have you had any issues with the adhesive not holding the vacuum bag down on the mold? I figured since the epoxy resin...
I plan to use epoxy resin to vacuum infuse a part in a wooden female mold. In order to ensure there are no issues with demolding I was considering...
I am planning to prepare a wooden mold to vacuum infuse a one-off part which is approximately 7m in length. I will most likely be using body...
