My experiences so far with surface veil tissues (assuming is the same thing as a surfacing mat) is they are a pain to use, quite difficult to...
So you think that as an avoider of printhorough a layer of 1 mm thick Atlac e-coat65, which is a sprayable material with no fibers in it will do...
Mr Rxcomposites you said "I use a surfacing mat after gel coat. It serves two purpose, one because it has such a high resin content and two, it...
I have read in your suggested link towards CCP cook book the pages related to gelcoat application and found them to be extremely well written and...
Mr Watson, you are probably very right, but if you look back in your time, you might remember being a novice and being overcautious about issues...
And shouldn´t the skincoat be applied slowly to avoid heat build up and contractions that could cause prerelease ?? ( I must say that my VE resin...
Hi rwatson and ondavr, rawtson: what you say is true from the "adhesion point of view" but not from the "avoiding prerelease point of view" off...
If you are a rhino user, Rhinocam is very very well suited ..........
good job your pioneering a new Rc trend
You are an incredibly efficient craftman ........ I wish you the best of lucks in your adventure and a lot of sales of your boat, you truly...
I will soon (in a month time) be infusing my first large piece, a 33 feet (10 meter) sportfishing boat hull in a female mould, and off course I...
Thank you Mr Ondavr for your very clear and complete explanation, I believe that I have fully understood it now, unfortunately so many different...
Ok, thanks for your time and expert advise ..
Hi Mr Watson & Mr rxcomposites, we plan on spraying everything, and we have airless gear to do that, in regards to the application of second...