west sys has a mat. called pro-set its a great thing. i use it to install bulkheads stringer,also deck joints the hand gun about 68$ tubes of...
the one way you could go about installing you core and works well is use corebond its made for this, lightweight so not adding much weight, spread...
if its like the 28 the hull is not cored it dose have coremat to aid with print thur so you dont see the checker board like older boats , and it...
you can go with starboard the make it with a nonskid pat. on it , I just did a job I used 3/4 and with sum alum. box to aid as a stiffer also a...
great boat just sold mine it was a blast road good the only down fall was the hatch cover in deck wood ,fell apart and gas tank rotted installed...
the hull is not cored, but they did use coremat to help with print thu after the skin coat , but like sam said check a thru hull cant hurt
it seems the kids today dont want to get dirty , Par ,I like the way you think
it has good hp, mabe a prop change for a beter hole shot , but you should do fine
watch out the yard I have my shop in has used them before , shafts to long, props dont fit and when they need pumps the bases are drill off in...
there is one other way a lot less sanding have your parts sand blasted lite a good blaster can blast heavy like 36 gt or as light as 180 gt cost...
I deal with a lot of boat manufacturers and some have gone to epoxy but went back to vinyl and polly due to the cost and the lay up time also...
you can try mini craft of florida they have classes all the time 1 800 282 8244 or www.minicraft.com hope this helps
thanks for the info , I will keep looking
thanks for the info looks like paint it is just have to watch when putting in and out of the water