Drain plug I use a 1/2" live well plug for my Clipper. Works great.
Actually, my new boat did not come with a data plate. My other one had a data plate but I have already sold it. Anyone else with a data plate...
I checked a few dimensions; the motor cavation plate is currently 1 3/8" below the hull. Transom is 15 1/2" tall and 42" wide. The angle of the...
The other boat had the same stringers on the bottom of the hull although I believe they were plugged at the ends (I'll plug them to see if that...
I have a 1958 14’ Orlando Clipper with a 25 hp motor on it. This boat is very nimble and will turn on a dime, top speed is 30 mph. This hull had...
There's not much on the internet about these boats. Here's a couple of sales brochures: http://www.theclassicboathouse.com/orlandoclipperad56.html...
clipper For reference, here's a photo of one of my clippers. This photo was taken about 75 miles south of Everglade City on the Wilderness Trail...
The rivets under my seat were bad too. Gooping sealant around a rivet is just a temporary fix. Best to replace the leaking rivets. I put about 6"...
orlando clipper You are correct; Orlando clippers were made in Orlando, FL. They were expensive in their day. They were made with a heaver gauge...