What type on inboard is it?
You have a non standard application. SHaft length of the outboard will be installation specific with the longest being preferable. The Cavitation...
My guess is 8-10 knts cruise; 12 knts max
???? 1. All the products utilized are epoxy based. 2. THe company you recommended does not make coatings for below the water line. Their...
Surface drives are easy to maintain, very straight forward...2 back to back thrust bearings and a need bearing. With a 2 speed gear box, full...
A single engine boat will have a torque steer issue at most speeds, torque steer trim correction found on the Anode above the propeller is only a...
Gonzo, I have never witnessed you pull a Kane. Your comment about the stern drive was applicable. A pod has more azimuth travel but essentially...
How does the flow change direction? The raw water circuit should have a pump? Consider spending $75 USD and put a water pressure meter on the...
Doesn't the pressure relief dump overboard?
I am using CV joints. GKN (Aquadrive CV 31); Initially my angles were to high but I corrected that. (not before I over-temped the joints and had...
Exhaust risers are not blocked (?) I flush the engine with a form of inhibited sulfamic acid after each run. There is increasing water pressure...
Today a raw water washdown system was installed with a bulkhead hose mount so salt- away can be circulated into the raw water distribution...
No problems Barry, you had me wondering...lol As I am running surface drive, when I redesigned the boat I moved the CG back 2 feet to prevent bow...
You said my original post said "42 knts"? Anyway, the movement of people on the boat is not very noticeable unless more than 2 people go to the...
LOL, I have found there are two types of boat ownership schemes; one is an owner with tons of money that knows nothing about the boat and makes...