Have had another few goes at it, best i've got is 0.11%, the plates up to midships are fine, no issues whatsoever, its when they start turning...
Hi, thanks for your reply, I started with a lines plan, then modelled and ruled the bottom first, then the chines, then the topsides, the frames...
Yes i most certainly will, don't intend to build this till over next winter, so have a long time from now until then to make certain that...
Hi again all, As a follow up from my last post about the new 7.5m design i completed (nearly completed) I am flattening down the parts, most of...
Yes the speed will be negatively affected, but not looking for speed, more interested in handling in poor conditions and stability, should be able...
Here's a picture of the bottom from the bow, can get another from the stern if that helps. [ATTACH]
Great formula, the deadrise at the aft end of this boat is 18 degrees, you are doing a lot better than me to work that out like that though, i'm...
Just tried it, to get the boat to go into negative trim, it would need 600kg's of weight in the wheelhouse, that would be the deck level, so...
I have only checked this with up to 5 people at 100kg in the wheelhouse which i thought would be a fair number in there, and the trim stays ok at...
Hi, I have run it through all calculations using Orca 3d and done manual calculations also, i have also had others with much more experience than...
Hello all, Just a quick post with a few rendered images of a boat design i have been working on now for a good while, designed in Rhino with Orca...
Morning, Thanks for your reply, the main reason i was looking at the fleck paint, was incase of the boat being used for fishing, in that case the...
Hi All, Hoping one of you may be able to help, i'm going to be building a 25ft sportfisher / cruiser, and have been doing a lot of research of...