No good?
Yeah it really suits me well. There is lots of room, really stable, economical ( 1ltr per 1nm @ 8.5kn). The ventilation only occurs at max speeds...
The prop is now prop speed. Will fair the trailing edge and maybe the rudder. I was advised that a smaller dia prop with more pitch might help?...
max rev 3300 rpm.
There is great knowledge in this forum. baeckmo, you are absolutely correct that the air travels down the corner between the hull and the keel...
How does the stern going down and the bow going up affect ventilation? When the boat is going 16kn, if you look over the side where the prop is,...
The boat semi displaces bow up a bit. Would trim tabs pushing the bows down help? What does a shroud look like? Would 300mm vertical boards about...
It's a cat. It draws under 1m so the props are close to the surface. 2 x 110hp, 16knot @ 90%.
I have a 42ft Power Catamaran which is prone to prop ventilation. This usually occurs at top revs and especially in a beam-on seaway. I'm looking...
Yeah Chuck she is an awesome boat. She is for sale for $419,000. Located in Sydney.
The Coventry conference sounds like a great initiative. When designing this boat for me, being in a wheelchair, we went through similar...
One of the main design considerations was to enable the helm to have good vision over the front bulkhead. To do this we raised the entire floor of...
Come on, it's just a forum. Any input or information is good because there isn't that much information out there on these type of projects.
Fair comment SamSam. I dug up a couple of construction photos. The first shows the engine and tank placement deep in the hull. The second shows...