Thanks rwatson this will work. I can see the cutting through one layer of glass and one layer of foam and leaving one layer of glass as being...
Rwatson - no plans exist. These are to be female Moulded sandwich halfs. The ideal method would involve minimal refinishing of the outer...
Thanks vmg The internal flange is a logical option. Thanks Alex
I am looking to get detail of the method that is used to join the two symetrical halves of a trimaran float. Or the deck and hull mould of a hull....
Some flat some curved, would be general hull construction over which curvature would vary
Greetings, Looking for some pointers on analysis of sandwich composite. I want to understand if the core will shear or skin will fail in...
Thanks Guys. I have some leftover laminating epoxy so will add a coat of this direct to the mold to seal. After a quick sand hopefully it's...
I have made a mold using mdf and faired it up with plaster. Sanded with 40 grit it looks ok. Bits of mdf and plaster are exposed. Can I roll a...
if a boat like this is to have a cabin - what is the minimum cabin size that would suffice
Looking at ways to build a dagger board. Rather than hand shape a core / glass / fair I was considering the following: Make split mold for...
"Place the center of area of the dagger board directly underneath the center of the sail area. " Thanks Eric Final quote from Sir Robert...
