I got a couple hours of grinding in today and the hull side of the CSM on my stringers appears very intact...only a few bad spots. How far down...
Ha! Thanks, though I am very familiar with that thread as well as his website. In fact, his restoration of that Citation is what inspired me to...
rasorinc: Just got done trying steam and it worked very well on the carpet glue that was under my splashwell, but has no effect on the stuff that...
How to remove carpet glue or left over adhesive without damaging woven roving This thread has been posted before but I haven't found any new...
I wondered that too but it even has the Glasspar speckled inside hull paint on it. Hard for me to imagine them doing this on the assembly line,...
I follow ya. I think I've been trained to pull the cap by so many others who've done so with my boat (or it's big sister the 16' Citation). It...
Thanks PAR, I will try to find that 12oz tape. 1/3 the epoxy...that will be some serious savings. I'm not sure I can handle cutting the cap...
Thanks for moving my post...sorry about that. I have the floor out and a closer look at the transom below the deck shows much more rot than the...
Cutting away final perimeter. I just finished getting most of the floor out. Most spaces were being held by carpet alone...aye! I have about 1"...
Thus far I've been afraid to remove them because I don't know the best way to go about it as they're flanged on both sides. There are three...
1960 Glasspar: stringers and transom questions I'm curious how I should decide whether or not to replace an old transom. I'm taking this 1960...