Bob Oram's kits are a lot cheaper than similar sized Schionning ones. Same material. Simpler and faster to build too. Something like a 39C would...
Might be worth investigating the warranty though. A few years ago even Kyocera's didn't give the 20 year warranty if the panel was used on a boat.
Lots of people have successfully built Easys, don't let all the negative people put you off! It could also be worth looking at some of Mike...
Another busy day: [img] [img] [img] [img] [img] [img] [img]
Working on it! [IMG] [IMG] [IMG]
Have you tried sailing with just one board down? You might be able to just remove one, leave the other in place, if space is more critical in one...
You want the props as deep as possible, to avoid (or at least reduce) them ventilating in lumpy conditions. My propellor shafts are 400mm below...
[img]
I did see that your galley is up, but don't see that that prevents you from having rounded edges on benchtops.
May be too late, since your benchtops are already cut, but I bent duflex through 180 degrees (router the glass off one side in a 45mm wide strip...
BIG day! [img] [img] [img] [img] [img]
A bit more progress: [img] We were lifting by the chainplates, and we told the crane guys the balance point would be just in front of them,...
http://www.australiawide.com/ed.htm?de=42757
I wonder if it would be allowed to race in the Sydney-Hobart?
Seems unlikely. A boat is going to have either one hull or more than one, isn't it? Although, a well known racing monohull designer did refer...
