I simply created a loft that travels through the 10 stations, since I had the profile of each of them.
Sorry for the confusing post. I've made a set of images to illustrate the situation. I hope it helps. I don't know if this is simply a...
Hi messabout, Thanks a lot for your answer! That's exactly the kind of feedback and information I was looking for. Some basic knowledge of what...
Hi All, Thanks for bringing the topic back to the software/ how to get the proper shape. I have noticed the following: If i look a section lines...
Hi again, Messabout: Thanks for your comments. As the situation evolves, and I come to understand the amount of work that I will need to do to...
Hello All, Thanks for all the feedback. So here is where I am at, after playing with my 3D model over the weekend: I realized that this...
I am contemplating a 12-14 ft boat made out of plywood. The drawings look like this so far. Is this doable? I have already gotten some...
Hi, I created a surface with network surfaces, and then just moved the control points. I'll keep on working on the surfaces. I am concerned...
So after some tweaking I think I am getting the gist of it. This is what it's looking like so far. Still has a bit of curve in the bow, but...
Thanks all for your comments! Do you usually tweak points in the longitudinal lines, or more in the vertical (section) lines? I am finding...
Hi David, Thanks for all the information. I see there is a lot of tweaking. I am an industrial designer, so I am quite familiar with...
Hello Gonzo, I will be sailing in big lakes, with moderate waves. Would like a boat that performs well all round. Sacrifices will have to be...
Hello, I am starting a new hull in rhino. Altough I have lots of 3D experience, when I loft the surfaces using sections I get some odd...
