I can use whatever. It’s just that I have more experience with epoxy. The problem I’ve always had with polyester is the narrow time window.
Do you think it’s doable with epoxy? I’m more comfortable working with this material. Also, what cloth combinations would you recommend?
The reason for the downsizing is that the original installation was too close to the waterline and cavitating like crazy.
It easier to get to it from the outside. Do you think I can use epoxy? Also, what kind of cloth? The lower half of the hole is about half an inch...
The new tunnel is made out of fiberglass. They recommend using isophthalic resin to bond it to the hull but I would rather use epoxy if...
Hi all, We had to cut an old bow thruster tunnel out and want to install a size smaller tunnel. What would be the right way to fill the roughly...
Those are Simrad EVO2, 12 and 16 inch. They're fine. I'm not big on touchscreens but it's impossible to find anything else this days. They are...
I just finished building my console. The box I'm building right now is basically a cover to cover all my wiring on the Bimini top, radar cable,...
You got it. If you have any questions let me know. I'm not a boiler expert but in my job as a marine electrician worked around them enough to have...
You got me here. I forgot about this set up.) You don't see this kind of installation very often. What they have here is they are using two...
Yes I red this and it confused me. I've never seen EGE and oil fired boiler run simultaneously,
Oil fired boilers, we call them auxiliary boilers, are only used in port when the mains are stopped, or at very slow speed, when exhaust heat is...
I think I found the answer! I think the way this ship was designed is to use two engines, the ones with the EGEs as primary engines to be run...
EGE is basically a water boiler mounted on the exhaust pipe. Hot gases coming from an engine pass around the water tubes in the EGE and produce...
This is what I've in mind
The box will be about 4' above the console so if I get the gelcoat color close it will be very hard to tell.
You're welcome. I wonder why they kept adding EGSs? I can see two, but four?
The reason why I'm thinking of taking the mold route is that the outside will be finished. I did my lower console the way you suggested, plywood...
Hi, I been following this forum for a while. Got a lot of valuable hints while building a console for my boat. I in the design process of...
Not sure about that CG vessel. On modern commercial vessels that stack area, also called fiddley, does contain engine room exhaust and intake fans...
