Merry Christmas fellas, all the best to all.
Yeah, once the particles are down, you do need to overcoat them with the paint, sorry I left that part out on my posting above
I had this problem whilst working in China on a very expensive brand of boats that had forgotten to put the non skid into the moulds, we did set...
Dennis, I have never cut a rudder, just made new ones, but it may be possible if you slice it thru the centreline (offset say 8mm to allow for the...
Have to agree with SukiSolo, why would you want to do it in 600. One would expect that you are looking for a full gloss finish on your products,...
Well mate, if you have built 3 boats already, you are well on your way. Just make another boat that you like then create a mold from it. Easy as that.
Can you just use a dog or cone clutch, we have and old engine here called a Blaxland (Blaxland Chapman Marine), I have a brand new one in my...
I have just listed on Ebay the above parts book if someone is interested....
You are aware that there is and up and a down side to the csm?, Have a close look, one side has the binder and the hairs do not stand up so much...
Just try putting the second sheet over the wet sheet and start rolling it out, most likely the sheet will wet out just from the amount of resin in...
We went from <1 billion to >7 billion in 100 years......says it all really, we MUST stop breeding. The world can recover, but we will not allow it...
You would be best advised to buy a used sailboat and toss some refurbishment/restyling/modifications into her....excellent advise mate, and with...
"We had access to carbide lamps and cider jugs, cliffs with a creek and rocks, abandoned coal mines and it is a wonder to be alive...
I read that the new island is belching poison gas. well you would not expect too much backchat then eh, could be cheap. __________________
Yeah, waves travel at between 12 to 18 knots, so the boat has to be slower or faster than that to keep water speed over the rudder. The object...
Attacking a boat at sea is piracy, whatever the "just" cause. Sink em.
It is only a tiny boat, not worth buggering about with patches, just redo the rear deck, and all is well. It is only a few feet of decking to do....
Do it once, do it right Hey mate, Remove the deck, replace the deck.....simple. Yes you have to remove all the fittings etc, but then at...
http://www.evworks.com.au/tech/?section=batteries These people will be supplying the gear (they do not know that yet)....looks like they have...
Hey fellas, I have been asked to assist in the installation of a Lithium Ion battery bank in a small cat here. There are available now...
