So what do we think would happen if the boat had level trim and you added the passengers who would be in the front half of the boat.
Here is a thought, if the boat weight is 4900kg and is deemed to to be over weight and you don’t put the allowed for 48 people onboard, only 8...
Bluebell this “Designed”, by who, a sixth grader? Is this based on your knowledge of Australian river boats? The look and construction, plus...
So his statement that “ It was built as a river cruiser that could also be used to operate pedal boats from, and was designed for commercial use...
Yes . statement in the original post “I will be adding furniture etc, and have a separate tally of that weight, which could be used to help the...
Question what is the point of trying to trim a half built boat when you don’t know where and what weight the other half is ? What is the designed...
Sywofp so what about the 500kg (approx) of glass in the front half and then the furniture and the galley/kitchen plus accommodation . A simple...
Mikejohn there is a quick way to fix the problem. Select the line, In the transform menu about half way down there is “set XYZ coordinates “. In...
Mikejohn I had no problem with offset in rhino 5 but you do have a problem with your keel line, it is not straight, this will create problems,...
Mikejohn as DC pointed out the fillet has some issues it doesn’t match edges with the adjacent edge which can effect trimming as there could be...
tyq the files are my blank starting file no compartments have been defined that would be up to you.
tyq here are two files, one is the whole hull which you can edit as an asymmetric or the half hull as symmetrical then move out to a centre line...
tyq you can have this maxsurf file if you want it is one of my blank starting files.
tyq power or sail? Picture of type of vessel would be good.
Jakenewcastleuniversity Here is the file of the foil but be mindful that this model was done for illustration so the foils were hand drawn and the...
Jakenewcastleuniversity do you want to create the vee foil in rhino so you can take it back into maxsurf? Something like this.[ATTACH] [ATTACH]
:)CT luv the double cultural reference
Zygan Maxsurf does not deal with trimmed surfaces from other programs it just imports the original surface. You also only need to import one side...
A little note of caution here about the standard extrude command it can create anomalies in the ends if the line has any curvature. The extrude...
Here is a start 15 to 20kg Choosing Winch Power http://www.harken.com.au/article.aspx?id=12821 Harken Sailboat Hardware and Accessories...
