S 9.681 [m2]; Bwl 2.182 [m]; Displacement 1.246 [t]; Draft (hull) 23 [cm] Area (hull) 22.723 [m2]
(preliminary sketch, no calculations)
multi chine plywood or moulded wood, epoxy, covered with fiberglass
ACC is a totally different story. Their design depends on formula combining WLL, sail area and much more. AC yachts waterline length is made...
The solutions below (attached sections) are commonly used. Better than the Match 42 system or CE specifications? At least some structural...
The waterline is fine. If you don't overload the boat - and you have some margin according to the drawing - the stern extension will be useless...
Tim: I agree 100% I was looking for Chinese funding, to promote their sailboat production. Perhaps not the best place to discuss this. ;)...
See attachments 1. Observe how the water flows at this level. If no whirls, you won't gain anything. 2. You need to have flat bottom hull...
Thanks for your advice normbaker. As you said, just try to dig a bit and nothing clear comes out from this. No problem, I have only ideas and not...
Sail boats in China Hello, I need informations and contacts about chinese production of modern cruising sailboats, if any! Could the Chinese...
