yes, you are talking deadrise at transom of 19 is ok, transom angle is the amount of degrees from verticle for outboard motor which should be 13...
angle trans should be 13 or are you meaning deadrise at transom? 6mm bottom plate would be better I reckon
Usually I put compound into plates, but my plate wheels are gone I is not advisable to pull plates into curved frames, as the plate is now under...
I am here to make aquantance and hopefully friends Who have built, designed, sailed bigger vessels as I have I am not interested in negative...
YES AGREE, the large tanks are for range, I do know about ballast, i built sailing yachts, good night
10mm abt same weight as 1/8 steel this boat will not be painted on topsides plate, the idea is for the plates to be fair after welding with just...
retail alu is 15k a tonne here our biggest compant offered 767o a tonne for certified plate I use best materials, best plate. best wire you use...
i have calced the weights I can stand any critique, but that person had not read the thread. You can see. I posted results from maxsurf I have...
tees form well, but probs not available here, frames have not much shape so angles are good cept may not be available, sawn flats 100 x 10...
thanks Mister, HAVE THE DOE RAY ME, the gear, but lost my left arm, can use lathe, saws, but good mig needs two hands , anyways, at the mo, I...
I am not at all fan of the flying bridge, in beam winds the boat will heel to windwards, sure trim tabs can fix that, but height is a factor on...
ok yes will redo glass, thanks
i doubt it, i have built more vessels than you have had hot dinners i know all of the weights, date lcf lcb plus it is prelim BTW I would rather...
what is deadrise station 2, for any kind of chop 42 degrees min
does this look dated[ATTACH]
sorta sorting it, lots volume , the will be a 12 inch sill cockpit to salon[ATTACH]
modelling the superstructure is a challenge, modern or more oldish[ATTACH]
turbo power has been here since 1940s look for Doxford
a rule of thumb and it is very usable , 2 imp gallons hour for each 50 hp
if you can read rhino, I will send the file
