I have GOT to find a use for this too...I'm sure you can find something creative! http://www.eplastics.com/Plastic/Rowlux_Illusion_Film
A few items of interest.... http://www.eplastics.com/About_ePlastics http://premierwindowfilms.net/low-e-window-film/ and my nightmare, I mean...
Just signed up to Boatdesign forum site I accidentally sent the message that was to be sent to this forum area to another place (I think I sent...
Just signed up to Boatdesign forum site "Casa Cayo" has been a real project! I've been doing most everything myself with very little help...
Just behind where the unit is to be is where the shower area is located....
The design is to beef up the area that did not originally intend on having an outboard attached. The transom is 1/8 thick aluminum (the boat, a...
Response to various responses Wow, thank you all so much for responding, I had no excuse for not getting a computer until recently...sure would...
The box-like structure hanging off the back of the outside of the boat (transom) is where a regular outboard motor (Evinrude 150HP) will attach....
Thru-hull spacer Thanks, I was leaning towards going with the aluminum spacer as a back plate for that. I will take your advice with the 5200...
That's my question, what would you use as a backing plate: wood or composite plastic or aluminum? (my hull is 1/8" aluminum.) Is 5200 rated for...
Venting of propane burner My burner is located OUTSIDE of the boat, why would I still need venting or use of a blower for that matter?
Ok, thanks in Lakeland. Yeah it was 6061 (T-6 harness) that I used for that thick frame I used to shore up the inside of the transom area (the...
Aluminum supply I found T-6 and 5052 at a place named: A.C.M.E. Industrial Surplus in Sanford, FL. 407-328-1280 They also have Titanium and all...
What I did with my Lund Well, it's been about a month since your post so you probably already cut out and layed down your front deck area. How...
The plan is to locate the propane hot water heater/burner unit OUTSIDE of the boat in a separate vented locker to protect somewhat from the...
Rubber washers The Maeleron fitting is bigger (diam.) than garden hose washers. Also, it has to absolutely water tight (over time as well.) I...
The plan is to install this male threaded thru hull onto a 90 deg. female elbow fitting so as to bring a hard line assembly up above the water...
