You can also develop the shapes (sides and bottom ) lay them up on a mica faced table then glass the whole thing together (Chine ,transom and...
http://www.cyberstreet.com/andre/
http://www.airtechonline.com/
On some of my small boats I used 5 stringers that cut down the open span (panel width) and made for a rock solid cockpit sole when it was all...
With the linear foams Hydromat is the logical choice, ASTM (D6416).
Just use a router with a small base and over cut a little to compensate for the inside radius if you have too (note your battens are flat) since...
See what line? you cut from the top edge to a set depth with a router, the width and the location are what you need to setup.
There are plenty of 20 year old boats out of that factory and the wiring is just fine. I hate slop BTW.
Exactly!
Yes a simple fixture on a table saw,or band saw ,two long wedges and a router setup with a mortising bit.
No I use the batten as a guide for the base of the router.
Location is important that is the reason I use the batten itself as a guide across the frames.
Yes I agree scarf and glue up the total lengths needed, then you can tack them to the frames using the offset of your router base to bit for a...
Who were you dealing with?
Years ago I found the same thing with the 18 Oz WR during testing.
The Wiring is exactly the same in the offshore race boats built there also that Have to live in a sea mist and splash, with no problems, in a high...
Dude a fitting becomes a pipe? When you buy it by the Foot or Meter, I would guess for one and DOES not come in Box with a part number would be a...
I would only use CF to a small percentage with "S" Glass,CF's problem is it has a very small elongation then catastrophic failure.
Why would you say something that stupid, To hear yourself talk? most fuel tanks come with aluminum stops anyway what the hell are you going to use...
I answered in post #10
