Here is Cleanup on a 11 Meter hull just pulled ,that is going together built with 1" Core and NO Bog or whatever,The fixture was built very close...
The sheets should be seated on the battens before you fasten from the back side,also that is why I use long pieces of batten to draw the face side...
Cat are you trimming the edge of the sheets for a close fit?
Duratec Grey primer on a 41 foot plug. [IMG]
Cat build a oven with some insulation foam from Home Depot and heat with a indirect propane burner, use #14 self tapping screws from the back side...
External mix you can see the MEKP spray and a Flow meter can be used as well ,The internal mix guns are where the operator needs to be alert and...
Duratec is the standard of the industry,Geltime? We never had a problem using MEK as the reducer,The plug work was always glassed 100% before the...
Herman is right the $500.00 for the alarm is cheap Insurance,I used the ProGun on a modified System One Venus rig ,Loved the Gun BTW Magnum owns...
I agree they are the only game in town that is dependable.
I would setup the MEKP spray with water to get the fan close then clean and spray some gelcoat on a plastic or metal target and then use a Gel...
Water will not damage corecell,you are confusing this material with something else,Core in general has got a bad rap due to poor shop practices .
I have used Vinylester Tooling Gelcoat in the past and the barcol was lower than the polyester Gelcoat, For production the ArmorCote would be a...
20 Years back I shot Linear PU (Clear) over a White Gelcoat deck and it started to get a tinge after a couple years, I got sterling out to look at...
You need to insulate the Oven, Polyisocyanurate boards from home depot will do and the Meat thermometers are a good idea,I would use a forced air...
Par is right, Here is a epoxy material,If you can not sand it clean then sandblast it and use this product:...
I know some people,How soon is this coming about?
There are tech manuals on the MEKP blends for side by side comparison,I do not know if the one I had was meant for consumer use (it was given to...
Production Molds I am pretty traditional,Two coats tooling Gelcoat then a layer of 3/4 or 1 oz Mat, cure, then two layers the next day and so...
I built my own recovery units and would get @75% back if they were used everyday and the tool buckets were covered. They sell lacquer thinner...
Exactly, that is a old boat and would use Epoxy on the rebuilding job,I mentioned West Systems, they have a website where you can get info.
