Wilson Flyer 17ft

Discussion in 'All Things Boats & Boating' started by Robert buis, Nov 16, 2025.

  1. Robert buis
    Joined: Nov 2025
    Posts: 0
    Likes: 0, Points: 0
    Location: Falkirk

    Robert buis New Member

    Hi. I have just recently picked up a wilson flyer and checked the hull through the round inspection hatches and noticed that there was about 8 inches of water. I did pump it out. Checked 3 weeks later and its got water again never been in the water but have had quite a bit of heavy rain. There is an electric anchor at the front could the water be getting in here. My question is can I drill holes from each compartment and fit a drain plug at the rear. There is some sort of pump molded into the sump at the rear not 100% sure. Thanks in advance bob.
     
    Robert buis, Nov 16, 2025
    #1
  2. TANSL
    Joined: Sep 2011
    Posts: 7,983
    Likes: 955, Points: 123, Legacy Rep: 300
    Location: Spain

    TANSL Senior Member

    Welcome to the forum.
    Yes, that's common practice. It's not necessary to install a bilge pump in every compartment, as long as it allows water to drain to the stern.
     
    TANSL, Nov 16, 2025
    #2
  3. Robert buis
    Joined: Nov 2025
    Posts: 0
    Likes: 0, Points: 0
    Location: Falkirk

    Robert buis New Member

    Hi thanks for the reply.
     
    Robert buis, Nov 16, 2025
    #3
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.