white spots in fiberglassed bottom

Discussion in 'Wooden Boat Building and Restoration' started by Nordson1960, Mar 24, 2005.

  1. Nordson1960
    Joined: Mar 2005
    Posts: 5
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Netherlands

    Nordson1960 Junior Member

    The bottom of my boat has been epoxy and fiberglassed. It looks like the former owner did not know all that much about epoxy because there are a lot of white spots (not enough epoxy used or not clean surface) My question is how should I deal with these spots

    Should I sand them down and lay glass over them again? Do I make small patches to cover them?


    Any help would be highly appreciated
     
  2. gonzo
    Joined: Aug 2002
    Posts: 14,478
    Likes: 647, Points: 123, Legacy Rep: 2031
    Location: Milwaukee, WI

    gonzo Senior Member

    Looks like what you are describing are air bubbles. Either they were trapped under the laminate or it was layed on too dry.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.