PAR
Yacht Designer/Builder
An 2:1 ellipse will do, 3:1 if you're going fast.
The Boat Design & Boatbuilding Site
Through Hull Discharge Design
- Thread starter SuperPiper
- Start date
SuperPiper
Men With Little Boats . .
Oops. I already had the templates drawn and cut for a 3:1 ellipse. And being a lazy *******, it was easier for me to do more work than required than to back up and redo the templates. By 3:1, you really meant a 6:1 half ellipse, right? I have a 6" long elliptical transition from a 2" diameter hole.
The photos show the progress so far. You will also notice that there is a time constraint on this project. The ice hasn't come off the lake, but the water level is fast approaching its spring high. We are off to Winnipeg to watch the Jets beat the Predators. We'll be back in a couple of weeks.
Have fun.
The photos show the progress so far. You will also notice that there is a time constraint on this project. The ice hasn't come off the lake, but the water level is fast approaching its spring high. We are off to Winnipeg to watch the Jets beat the Predators. We'll be back in a couple of weeks.
Have fun.
PAR
Yacht Designer/Builder
Oops, yeah, that's what I meant . . .
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
Advertisement:
