Tapered chine width

you have that right, the entry is very important, the deadrise of the red boat is too constant, , the deadrise I have found needs to be steep at the bow, and end up about 20-22 stern, the boat then gan be driven hard from crest to crest, where as on the first of those photos of mine, the bow was kinda spoon shaped and we had to slow considerably, in the rough no matter how much you slow, a bow with flatter sections will pound so bad that you have to come off of plane,
When I changed to fine sections, nothing would stop the boat, I had a 20 footer that could outrun anything, and I do mean anything. Will try find the lines

 

That is an interesting hull Ranchi. I am sure it is very stable both at rest and at speed. How does it behave in a chop, are those sponsors making it harder riding? How did it behave when truning, I expect very little heel? Do you have any sea-trial video to share with the rest of us so we can see the boat in action.

BR / Jon

 

You can see the video on my Boat Design Gallery in this Forum with other ASD boats with speed up to 86 knots.

 

Need help on Manta

Hi Mr. Otto

We are model makers based is Singapore, sorry that I have to contact you through this thread but I need your help.

I have been contracted to make a model of the Manta designed by you. I have some drawings and photos but they are the same as those on the net. I need some view from the top back.

Let me know if you can help.

I can be reach at dennis_low@gencast.com.sg

http://www.gencast.com.sg/HModels-Marine.html

Thank you for your time.