Surface/surface intersections tolerance in Rhino.

Discussion in 'Software' started by Alexanov, May 4, 2019.

  1. Alexanov
    Joined: Feb 2003
    Posts: 235
    Likes: 30, Points: 38, Legacy Rep: 10
    Location: Norway Sola

    Alexanov Senior Member

    When I try to import my hull surface into Aveva I have got warning about gaps between surfaces. Aveva found gaps where I have surfaces, trimmed by intersection line. Some people said that to satisfy Aveva surface import routine I have to keep tolerances less them 1e-9 mm. I try to set such tolerance in Rhino and re-intersect this surfaces again, but never get result. Rhino just go into loop and not came back. Any ideas how I can increase intersection precision in Rhino or may be advice how to pass Aveva import?
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.