Shell Plate Expansion and type of forming process

Discussion in 'Boat Design' started by Navdes_E, Feb 5, 2011.

  1. Navdes_E
    Joined: Jul 2009
    Posts: 13
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Turkey

    Navdes_E Junior Member

    Hello,

    I'm working on 30.00m. trawler yacht hull form design with MAXSURF. I started to design hull shell plates in WORKSHOP, but there are some doubts about this process;
    1- When i checking my plates in Parts/Development window, i see there : "Max. Girth Difference from aft to fwd : 17mm"
    "Max. Girth Difference from outer to inner : 5mm"
    Are these values too much for expansion tolerances?

    2- Which method should i use for reliable plate expansion result? ( General, Fabric, Old Developable)

    Looking forward to your replies.. Thanks..
     
  2. naserrishehri
    Joined: Jun 2006
    Posts: 156
    Likes: 0, Points: 16, Legacy Rep: 10
    Location: iran bushehr

    naserrishehri Senior Member

    check your results by rhino squish plug in
     
  3. Navdes_E
    Joined: Jul 2009
    Posts: 13
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Turkey

    Navdes_E Junior Member

    i have not got rhino squish plug in :(
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.