Prosurf 3.0

Discussion in 'Software' started by Luis M Pinho, Mar 17, 2009.

  1. Luis M Pinho
    Joined: Mar 2008
    Posts: 9
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Brasil

    Luis M Pinho Junior Member

    Hi all,

    I have a full license Prosurf 3.0 for a couple of years. I first intended to use it as a nurbs modeler, but later bought Rhino 4.0 for that purpose, but I still use Prosurf 3.0 for some tasks, such as line fairing, NACA foils generation, txt output of geometry and so on.

    Recently I bougth a new computer and wanted to install it there, but you have to get a new key each time you install it.

    I wrote to the email address on the web site and got no reply so far.

    Any one out there that had a similar problem and could help?

    Thanks in advance,
    Luis
     
  2. CGN
    Joined: Jan 2003
    Posts: 547
    Likes: 9, Points: 18, Legacy Rep: 138
    Location: MX

    CGN Senior Member

    sometimes is hard to get in contact Stephen but no doubt he is there just keep trying.

    I understand is frustrating but he'll will answer, there has been some other comments that it takes some time to hear from him, i went trough the same but i had my key and is working just fine

    cheers
     
  3. Luis M Pinho
    Joined: Mar 2008
    Posts: 9
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Brasil

    Luis M Pinho Junior Member

    All OK

    Hi,

    Steve got back to me and all is fine now!

    Thank you very much for your reply!

    Best Regards,

    Luis
     
Loading...
Similar Threads
  1. Luis Pinho
    Replies:
    2
    Views:
    1,624
  2. Troutcatcher
    Replies:
    6
    Views:
    2,532
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.