production FRP tool / mold construction

Discussion in 'Fiberglass and Composite Boat Building' started by brokensheer, Apr 29, 2014.

  1. brokensheer
    Joined: Jun 2009
    Posts: 201
    Likes: 3, Points: 18, Legacy Rep: 14
    Location: So. Md

    brokensheer Senior Member

    I have noticed a bit or questions here about this subject. I would like to see a thread dedicated to building tooling and production molds, I have a small skill hull mold and I wish to build an interior hull liner that will sit upon the stringers, my delema is this skiff has a bit of tumblehome in her stern so I may hace to build the liner in two pieces to slide in the aft section first then repair a "beauty" line joining the fore section,, ! any pictures are welcome
     
  2. brokensheer
    Joined: Jun 2009
    Posts: 201
    Likes: 3, Points: 18, Legacy Rep: 14
    Location: So. Md

    brokensheer Senior Member

    trim tab pocket mold

    this part can be used in production female molds by trimming and setting in in the mold on some clay, or a femae part can be pulled and used in a retro-fit application
     

    Attached Files:

  3. redreuben
    Joined: Jan 2009
    Posts: 2,052
    Likes: 247, Points: 63, Legacy Rep: 349
    Location: South Lake Western Australia

    redreuben redreuben

    If the tumblehome is not extreme or has other shape locking the part in it can usually be released by lifting the front out first and sliding the whole part forward over the bow.
     

  4. brokensheer
    Joined: Jun 2009
    Posts: 201
    Likes: 3, Points: 18, Legacy Rep: 14
    Location: So. Md

    brokensheer Senior Member

    Thanks redreuben,,, we made our "tool: with the guards already in place
     

    Attached Files:

Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.