Ok, its time has come

Discussion in 'Motorsailers' started by dem45133, Sep 10, 2007.

  1. dem45133
    Joined: Aug 2006
    Posts: 38
    Likes: 2, Points: 0, Legacy Rep: 22
    Location: ohio

    dem45133 Junior Member

    With two summers of fishing Lake Erie under my belt I have a question...

    I almost, repeat almost, bought an older Sportcraft 27ft sportfisherman... 454 inboard... but the $1.75 per minute to criuse is simply not doable (I haven't won the lottery yet!)

    My friends 25 ft sport fisherman uses $70 worth of fuel to go the 15 miles and back at about a 23 mph (sorry, gps set to mph) on the most efficient plane/trim engine rpm I could get. And this boat gets an "economical 1.5 mpg", big blocks are generaly in the 1 or <1 mpg range. Many of these guys no longer go out unless they can get several people together to share the fuel costs... then leaving their own boat in the slip. This year fuel topped $3.80 gal at their marina.

    Thinking 27-28ft sail / motorsailor, but Lake Erie is unpredictable and when your 14 miles out and the weather changes, a 6-7 knot sail or 5-6 knot aux powered simply takes too long to get in.

    Whats needed is real efficient displacement haul that can slice through the water, maintain a 14 or 15 knot cruise... maybe more... and not break the bank on fuel.

    Seems to me a slightly slower but very efficient displacment hull (maybe even aided by sail for those so inclined, like me) is possible... and still be able to power in and take on 6 ft seas (NOT uncommon) when the weather catches you. Most watch the weather like a hawk... but Lake Erie often fools everyone.. even the weather man.

    Oh, and draft need to be shallow, as most of the fish camp marinas are not deep enough for conventional sail drafts.

    Personally, whatever boat I get has to be trailerable... don't care if its seventy feet and I need to get a semi truck... but it comes home for the winter in my own shed. My 3/4 ton will pull 10k thus I'm currently limited to about 28 - 30 ft or so. I don't really care if it needs a wide load permit... I'll get one.

    Any ideas?

    Dave
     
  2. SAQuestor
    Joined: Sep 2003
    Posts: 163
    Likes: 14, Points: 0, Legacy Rep: 91
    Location: San Antonio

    SAQuestor Senior Member

    A pure displacement hull form won't get it for you. Figure it out from this: Square root of the waterline length X 1.34. No matter how much power you add, ya ain't gonna go much faster with a pure displacement hull.

    IMO you need an excellent semi-displacement hull form. A hull that will economically cruise at 8-10 knots (2-3 NMPG, maybe a bit more if you go a bit slower) but still be able to kick it at 15-18+ knots to get back away from those sudden storms.

    As just one example, take a look at Paul Riccelli's gallery. Especially the RYD 26 design. Semi-displacement, pilothouse and cuddy - perfect for getting out of the weather. Large cockpit for fishing. And trailerable. Power choices from outboard to full inboard.

    Other examples abound. Since I'm on my lunch at work I do not have access to other links from my home computer. Will post several other links tonight.

    Best,

    Leo
     
  3. dem45133
    Joined: Aug 2006
    Posts: 38
    Likes: 2, Points: 0, Legacy Rep: 22
    Location: ohio

    dem45133 Junior Member

    Thanks SAQuestor... looking forward to your links.

    Looks like I need to research "semi-displacement". I probubly mis-used the term "displacement" per say...thinking more along the lines of simply non-plane.
     
  4. alan white
    Joined: Mar 2007
    Posts: 3,730
    Likes: 123, Points: 0, Legacy Rep: 1404
    Location: maine

    alan white Senior Member

    Regardless of how unpredictable the weather, seas do no build that fast, except in rare circumstances. The idea of a motorsailer is fine, but motorsailers are really not generally faster than sailboats--- they are simply designed to motor more often at closer to hull speed.
    The idea of paying a dollar to go one mile, to me, is patently ridiculous. Yet even what supposedly passes for an efficient powerboat might cost that much to run.
    A displacement boat pays the least penalty of weight of all hull types. Something 25 ft long and 3 tons, trailerable at the upper limit without hiring the transport done, could achieve 10 mpg or better. What allows this is the hull being designed specifically to move most efficiently at a low speed, say 5 kts.
    Sailboats commonly get similar (10 mpg) mileage figures when they motor, even if they are very efficient hulls for sailing too. The water really doen't know what's making the boat go. It's the hull that matters.
    Displacement hulls also happen to do better than planing hulls when conditions get rough. They have more rounded bottoms and narrower transoms as a rule. They also usually have lower centers of gravity.
    A very comfortable cruising yacht 25 ft long, 3 tons, with 15 hp or so diesel inboard won't be so much bothered by rough conditions if it is designed right.
    Such boats exist. They are not fast boats. They will be cheaper to run, however. And a sailing rig never hurts when the iron wind fails.

    Alan
     
  5. Guillermo
    Joined: Mar 2005
    Posts: 3,644
    Likes: 191, Points: 63, Legacy Rep: 2247
    Location: Pontevedra, Spain

    Guillermo Ingeniero Naval

  6. SAQuestor
    Joined: Sep 2003
    Posts: 163
    Likes: 14, Points: 0, Legacy Rep: 91
    Location: San Antonio

    SAQuestor Senior Member

    Dave,

    I had every intention of posting a dozen links in response to your earlier post.

    But I think that these three will be sufficient.

    Sounds to me like you want a economical fishing boat that will run all day inexpensively but have the speed to get from 20+ miles out to shore in less than an hour. Right?

    Start looking here.


    Then look at this Yahoo group.

    Finally, if the Tolman design doesn't ring your "gotta have" bell, try this link for lots of Downeast boats. I'd particularly look at the Dyer 29 as a suitable craft for your use.

    IMO of course and YMMV and all those other qualifiers. :)

    Best,

    Leo
     
  7. lewisboats
    Joined: Oct 2002
    Posts: 2,329
    Likes: 130, Points: 0, Legacy Rep: 1603
    Location: Iowa

    lewisboats Obsessed Member

    http://www.skiffamerica20.com/

    very efficient boat for it's size...it planes with a 25 hp and gets good mileage. It might be a bit small for your needs but Kilburn may be able to do a stretch model for you.

    and here is another...: http://www.bluejacketboats.com/

    The hype sounds good and I have heard/read good thing too
    Steve
     
  8. Pericles
    Joined: Sep 2006
    Posts: 2,015
    Likes: 141, Points: 63, Legacy Rep: 1307
    Location: Heights of High Wycombe, not far from River Thames

    Pericles Senior Member

  9. kengrome
    Joined: Jul 2006
    Posts: 718
    Likes: 25, Points: 0, Legacy Rep: 305
    Location: Gulf Coast USA

    kengrome Senior Member

    Maybe what you really need is an efficient planing hull. Here is Slicer from Phil Bolger:

    http://www.duckworksmagazine.com/05/excerpts/maib/1/index.cfm
     
  10. dem45133
    Joined: Aug 2006
    Posts: 38
    Likes: 2, Points: 0, Legacy Rep: 22
    Location: ohio

    dem45133 Junior Member

    Thanks all... it'll take me a bit to check out all the links and it won't be today... still researching... especially a concept call "powersailors". Sort of a marrage all all three basic hull forms. Yes, which likely is inefficient in any one, but its intriging to say the least.

    Will get back to you all...

    Dave
     
  11. dem45133
    Joined: Aug 2006
    Posts: 38
    Likes: 2, Points: 0, Legacy Rep: 22
    Location: ohio

    dem45133 Junior Member

    to: Alan White

    Yea Alan, me too, which why I started this thread... but "only" a dollar per mile would make my fishing buddies go giddy with joy.

    When I calculated the running cost on a 27 ft 454 V-8 powered sport fisherman at 1 mpg (the concensus of other 454 big block owners)... it came to 1.65 per minute at least years fuel cost at "criuse". Since "cruise" according to Sportcraft for this boat was 27 knots (about 30 mph... max was 41 knots BTW... we wont even calculate that big 4 barrel being opened up all they way)... 1 mile is approx 2 minutes... at 1 mile per gal at $3.30/gallon is $3.30 a mile at last years prices. Was $3.80/gal for a bit this year. Yes, a more relistice 25 mph criuse would be a little less, but not all that much.

    I don't know if I can even fathom what (well actually I can,its just numbers) what those 50 or 60 ft triple engined giant block supercharged boats cost to run at their 55 knot or whatever cruise... let alone opened up. I've heard of unoffical boy toy races accross Lake Erie, where they routinely hatch out $100,000 powerplants and think nothing of it! Just one of them would pay off my mortgage!

    But, I know, $ is evidently a relative thing. Like most, just never had enough to get that serious on play items.

    later,

    Dave
     
  12. alan white
    Joined: Mar 2007
    Posts: 3,730
    Likes: 123, Points: 0, Legacy Rep: 1404
    Location: maine

    alan white Senior Member

    $1.65 a minute... imagine that!
     
  13. FAST FRED
    Joined: Oct 2002
    Posts: 4,519
    Likes: 112, Points: 63, Legacy Rep: 1009
    Location: Conn in summers , Ortona FL in winter , with big d

    FAST FRED Senior Member

    You might consider pulling some of the posts ,on the Atkin New Jersey Sea Bright Skiff.

    These seem to be very seaworthy and the claim is very fuel efficient too.

    My goal is 18K at 3 or 4 gph, but if you plug in Canadian fuel prices, 3gph is about $12 per hour and 4gph would be about $16.

    Sure, slower would be cheaper , so two miles per dollar could be done (10K?)

    Almost a buck a mile is a reality , unless you can use a very seaworthy open boat.

    The Robb White version of an Atkin Sea Bright was claimed to get 35mpg at 18 to 20 mph.

    The best I have ever heard of , but it was an open very light boat .

    All the Sea Brights were built beachable , no machinery damage on running aground, and if narrow enough trailerable on a flat bed.

    FF
     
  14. kengrome
    Joined: Jul 2006
    Posts: 718
    Likes: 25, Points: 0, Legacy Rep: 305
    Location: Gulf Coast USA

    kengrome Senior Member

    Actually this is what his web site says:

    "... gets about 28.6 nautical miles per gallon
    of Diesel fuel running at its most economical
    speed of 10.5 knots."

    Not quite what you posted Fred, but still much better than any other boat I know of.
     

  15. eponodyne
    Joined: Aug 2007
    Posts: 327
    Likes: 13, Points: 0, Legacy Rep: 171
    Location: Upper Midwest

    eponodyne Senior Member

    Just a beautiful boat, too. Absolutely gorgeous.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.