89 Carver Santego 3867 nav lights wiring problem

Discussion in 'Electrical Systems' started by Charlie54, May 13, 2011.

  1. Charlie54
    Joined: May 2011
    Posts: 1
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: New Jersey

    Charlie54 New Member

    I'm trying to figure out how to post a question on this forum. Hope this works. I have a 1989 Carver Santego 3867 and recently had my hands inside the electronic box mounted under the radar arch to remove an old bracket. After I was finished, I discovered my forward nav light and all my bridge lighting no longer work. My center mast anchor/running light works but the forward nav lights that operate off the same switch do not. Any idea what I may have done while my hands were in that box? I'm thinking I must have accidentally pulled wire off from some where but with limited visibility, I can't find one. All suggestions are welcome.
     
    Charlie54, May 13, 2011
    #1
  2. gonzo
    Joined: Aug 2002
    Posts: 16,796
    Likes: 1,718, Points: 123, Legacy Rep: 2031
    Location: Milwaukee, WI

    gonzo Senior Member

    Unfortunately, I think that is a hands-on job.
     
    gonzo, May 14, 2011
    #2
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.