1. The Marketplace Forums can be useful for members who know one another well from forum discussions and offline communications and wish to post boatbuilding tools, drafting tools, molds and tooling, and other professional equipment for sale or trade. However, caution and good judgement should always be used. Especially when considering any business with anyone not already well known to you and trusted, due diligence must be used to confirm details and identity and be sure the transaction is safe before any money or property changes hands. Always use good judgement and perform due dilligence and follow these guidelines.

Molds for 33' Downeast For Sale

Discussion in 'Boat Molds' started by gsdickes, Aug 1, 2013.

  1. gsdickes
    Joined: Dec 2004
    Posts: 9
    Likes: 1, Points: 0, Legacy Rep: 13
    Location: Florida

    gsdickes Dickes Yacht Design

    The tooling for the former Black Horse 33 is for sale. This boat is one of my designs and is traditional above the waterline and state-of-the-art below. A lot of effort was invested in refining the bottom to reduce the drag inherent in a full keeled hull and still carry the engine low. The result is class leading speed and efficiency from a hull that also delivers an exceptional ride, tracks true and offers real running gear protection. You can expect 30 knots from 440 hp at 16,000 pounds. A Yanmar 480 can be accommodated entirely below the main deck allowing for both a low profile and 6-4 headroom without an engine box. Headroom down and forward is 6-1.

    Inventory includes the hull, side decks & trunk cabin, deck house and top molds. The set will produce soft and hard topped express models as well as long and short house sedans. The sedans will accommodate a flying bridge. Hull & deck molds have had three pulls, house has had one and the top has had two. This is very high quality tooling, built by one of the old Maine masters and is stunningly fair (see photos). All the molds have been meticulously cared for and were originally intended to produce a minimum of 50 pulls. A replacement cost of over $250,000 has been quoted.

    Principal Dimensions:

    LOA (molded) . . . . . . . . . . . . 33-0
    LWL . . . . . . . . . . . . . . . . . . 30-5
    Beam (molded) . . . . . . . . . . . 11-2
    Draft . . . . . . . . . . . . . . . . . . 3-8
    Design displacement (lbs) . . .13,700

    Asking $75,000

    Email for additional details.

    (Click thumbs for larger images)
     

    Attached Files:

  2. rcooper
    Joined: Feb 2013
    Posts: 0
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: fl

    rcooper New Member

  3. rbrooks
    Joined: Jun 2009
    Posts: 12
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Washington NC

    rbrooks Junior Member

    Hey Geoff,
    are these the same molds I looked at some time ago.
    Thanks
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.