Maxsurf Structure

Discussion in 'Software' started by inthy87, Jan 13, 2016.

  1. inthy87
    Joined: Jan 2016
    Posts: 1
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: italia

    inthy87 New Member

    Hi! i have any questions about this module,
    1) Can I insert opening into Stringers?
    2) How do I see the surfaces trimmed with Modeler in Structure?

    Thanks you for any answers!

    Best Regards,

  2. formsys
    Joined: May 2007
    Posts: 91
    Likes: 5, Points: 0, Legacy Rep: 50
    Location: Australia

    formsys formsys

    No, stringers do not contain openings, you will need to add them downstream in CAD. If trimming is turned o then frames will automatically trim to the trimming of the surfaces. Also if you add hull plates they will automatically be trimmed to the surface trimming boundaries.
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.