How to make station molds from an existing canoe?

I made a much simpler version of that device back in the 1980's.The difference was that instead of displaying numbers for the points along the section,it had a small hole for a pencil to mark the progress of the line on a large sheet of paper that was attached to the upright board.The board was attached to a pair of T shaped frames that held it upright and the whole thing moved along the hull for the various sections.A fine tipped pointer may have introduced a tiny bit of inaccuracy,but not enough to get too bothered about.
 
You must log in or register to reply here.
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.

    • Similar threads

    D
    Easiest Helm Station from Scratch Tutorial!
    Replies
    0
    Views
    3,067
    debergeracdesig
    D
    Robinfly
    Materials for building molds stable to the post curing process @70°C
    Replies
    4
    Views
    2,989
    ondarvr
    ondarvr
    M
    Modify/extend existing mold
    Replies
    5
    Views
    2,525
    mrdebian
    M
    M
    Making a new plug/mold from existing mold
    Replies
    3
    Views
    3,276
    wet feet
    W
    Back
    Top